Cleveland KET-20-T Service Manual download pdf (Page 4)

ASSEMBLY

Table-Top Models (3, 6 & 12 gallon)

Base Mounting Diagram

Table-top models (3, 6 & 12 gallon - single and twin)

must be positioned on a firm, level stand, or existing

counter top, and bolted in place. These models are

supplied with four threaded mounting bushings

welded to the underside of the base. An optional

support stand with level adjustable legs is available.

Once the kettle is secure, screw tilt handle into the

threaded hole provided at the right side of kettle.

Floor Type Leg Mount Models (20 gallon)

Base Mounting Diagram

Position on a firm, level surface, and bolt two

flange feet in place. Once the kettle is secure,

screw tilt handle into the threaded hole provided

at the right of kettle.

ELECTRICAL

ENSURE THE ELECTRICAL SUPPLY MATCHES

THE KETTLE'S REQUIREMENTS AS STATED

ON THE RATING LABEL.

This kettle is built to comply with applicable

standards of manufacturers. Included among

these approval agencies are UL, NSF, ASME/Ntl.

Bd., CSA, ETL, and others. Many local codes

exist, and it is the responsibility of the owner and

installer to comply with these codes.

The electrical supply must match the power

requirements specified on the kettle’s rating plate.

The copper wiring must be adequate to carry the

required current at the rated voltage. Refer to the

Specification Sheet for all electrical specifications.

Note: Maximum voltage for LVD (low volt

directive for Europe) to be 440 volts for CE

marked appliances.

WIRE CONNECTION

If unit does not have cord and plug option, remove

the screw at the rear of the console cover and

remove the cover. A wiring diagram is affixed to

the underside of the cover. Feed permanent

copper wiring through the cut-out in the rear or

bottom of the console, and fasten to the three

connection terminal block, which is mounted on

the top of the console’s control panel. Be sure to

connect the ground wire to the separate ground

terminal connector (ground lug). Replace console

cover and secure it with the screw.

The kettle is wired for 3-phase operation at the

factory. For single phase operation, rewire the

terminal block to that shown in the above diagram.

RED

YELLOW

BLACK

BLUE

RED

L1 L2 L3

THREE

PHASE

RED

YELLOW

BLACK

BLUE

RED

L1 L2

SINGLE

PHASE

28 1/2" 2 1/4"

14.5"

32"

12"

1 1/4"

KET-20-T

Model # A B C

TKET-3-T 18" 2 1/4" 1 1/4"

TKET-6-T 24" 5 5/8" 4 7/8"

TKET-12-T 30" 7 7/8"

7 3/4"

14 1/2" 1 1/4"

12.5"

18"

10"

1 1/4"

1.25 "

KET-3-T

KET-6-T

KET-12-T

TKET-3-T

TKET-6-T

TKET-12-T

5/16" - 18

threaded

bushings

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Cleveland KET-20-T Service Manual Page 4

Comments to this Manuals

Related products and manuals for Electric kettles Cleveland KET-20-T