Cleveland Open Base & Modular Gas Skillet SGL-30-TR Operations Instructions download pdf (Page 7)

START UP PROCEDURE

This appliance has been factory tested and adjusted

under ideal conditions but, rough handling, low gas

pressure, altitude or variations in gas characteristics

may require fine adjustment.

All units are equipped with fixed orifices and do not

require primary air adjustment.

LIGHTING INSTRUCTIONS

NOTE: This appliance is equipped with a direct spark

ignition system. Ensure gas and electrical supply to the

appliance, are in the 'ON' position.

1. Turn the main manual gas shut-off valve to the 'ON'

position.

2. Turn power switch to the 'ON' position.

3. Set thermostat to desired temperature.

4. If ignition fails and/or the control system goes into

lockout, set power switch to the 'OFF" position.

5. Wait 5 minutes then repeat steps 1 through 3. If the

problem persists, have a qualified serviceman

check the system.

6. To shutdown system, turn power switch and main

manual gas valve to the 'OFF' position.

OPERATING INSTRUCTIONS

1. Ensure gas and electrical supply to the appliance

are in the 'ON' position.

2. Turn power switch to the 'ON' position. The green

pilot light will indicate power is on. Wait one minute

to allow flame sensor to heat up.

3. TILTING OPTIONS

Note: Before tilting the pan make sure the lid is

open.

PowerTilt

Cleveland skillets are equipped with an electric

power tilt mechanism for raising and lowering the

frypan. To raise frypan, raise the cover and press up

on the tilt switch. To lower frypan, press down on the

tilt switch.

Manual Tilt

Cleveland skillets can also be equipped with the

optional manual tilt mechanism for raising and

lowering the frypan. To raise frypan, raise the cover

and turn the wheel clockwise. To lower frypan, push

in on the lever located behind the wheel.

4. FOR YOUR SAFETY, this skillet is also equipped

with a power interrupter which automatically shuts

off the gas supply to the burners whenever the

skillet is raised more than 1/2" (13mm).

5. Turn power switch to the 'OFF' position when skillet

is not in use.

6. During an electrical power interruption, turn power

switch to the 'Off position. This unit cannot be made

to operate without electrical power or gas supply.

OPERATING SUGGESTIONS

IMPORTANT: Always raise the spring assist cover

before activating the tilt mechanism. Before

commencing to cook, ensure frypan is in the lowered

position by pressing down on the tilt switch.

1. To preheat, set thermostat to desired cooking

temperature. The amber pilot light will cycle on and

off with the thermostat.

2. Allow skillet to preheat for approximately 15-30

minutes.

3. Once preheated, insert product in skillet and adjust

thermostat to required cooking temperature.

4. If desired, once product has cooked, it can be held

prior to serving at a lower temperature setting.

5. When cooking is completed, set thermostat and

power switch to the 'OFF' position.

6. The best time to clean the skillet is immediately after

use, once skillet has cooled down.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Comments to this Manuals

No comments

Cleveland Open Base & Modular Gas Skillet SGL-30-TR Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Deep fryers Cleveland Open Base & Modular Gas Skillet SGL-30-TR