Cleveland KGT-25-T Operations Instructions download pdf (Page 25)

LUBRICATION PROCEDURE

Lubricate the following parts every three months to

insure smooth operation and reduce wear.

TRUNNION

HOUSING,

WORM SCREW

AND TILT GEAR

These parts are

accessed through the

top cover of the

console.

Apply grease to gear

teeth. Check for

excessive play and adjust with adjusting screw located

on top of cross bar.

KETTLE

TRUNNIONS

On the left hand side of

the kettle there are two

grease nipples on the

top back portion of the

trunnion housing. On the

right hand side of the

kettle you must remove

the console cover to

access the grease

nipple.

Trunnion Housing

Grease Nipple

Adjusting

Screw

Worm

Screw and

Tilt

Gear

Cross

Bar

HINGE ADJUSTMENT

INSTRUCTIONS

1. Insert 3/8" Allen wrench.

2. Turn clockwise to relieve tension on spring.

3. While tension is released remove one of the two

slotted screws.

4. To prevent Allen wrench from springing back

abruptly while the second slotted screw is removed,

insert a pin (approximately 1/8") in the hole where

the first slotted screw was removed from.

5. Remove second slotted screw.

6. While holding Allen wrench remove pin.

7. Turn Allen wrench clockwise to tighten or

counter-clockwise to loosen tension to produce

desired effect.

8. Re-insert pin in one of the two holes.

9. Tighten one slotted screw in the other hole (it

may be necessary to turn Allen wrench slightly to

align holes).

10. Remove pin and repeat step number 9. for other

slotted screw.

3/8" Allen wrench

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 34 35

Comments to this Manuals

No comments

Cleveland KGT-25-T Operations Instructions Page 25

Comments to this Manuals

Related products and manuals for Electric kettles Cleveland KGT-25-T