Cleveland 24-CGA-10 Owner's Manual download pdf (Page 11)

CHAPTER 2 GENERAL OPERATION

A. MAIN EXTERNAL POWER SWITCH

Usually the steamers main external power switch is left ON.

If the main external power switch is OFF, turn it ON as

follows:

1. OPEN water supply valves

2. Turn ON/OFF switch to OFF (Figure 2-2)

3. TIMED/MANUAL switch and timer settings are not

important in this procedure. Control panel circuits are

not powered while ON/OFF switch is OFF

4. Refer to Figure 2-1. Use main external power switch to

turn on electric power to steamer. Steam generators will

immediately start blowdown cycles. Blowdown cycle

lasts 3 minutes.

Figure 2-2 Compartment POWER

ON/OFF Control

B. DOOR INTERLOCK SWITCH (OPTIONAL)

The steamer compartments of the SteamCraft

Steamer can be equipped with automatic steam cutoff

switches, which turn OFF the production of steam to a cooking compartment whenever the door to that

compartment is opened.

NOTE: Even though the continued production of steam ends as soon as a door is opened, it may take

up to a minute for residual steam in the system to clear from the steam lines and the cooking

compartment. To avoid possible injury always wait until this residual steam has cleared before reaching

into the cooking compartment.

C. POWER ON (AUTOMATIC FILL)

Use this procedure at the start of a shift to prepare the steamer for operation without starting steam

generation.

When the steamer is turned ON, the steam generator automatically fills with water.

teamCraf

DRAIN LINE

MAIN EXTERNAL

POWER SWITCH

Figure 2-1 Main External Power Switch

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

No comments

Cleveland 24-CGA-10 Owner's Manual Page 11